Luchador
RRCRat Rig Community [Unofficial]
•Created by Luchador on 3/12/2025 in #fix-my-printer
bed flat/even but bed mash shows different
19 replies
RRCRat Rig Community [Unofficial]
•Created by Luchador on 5/31/2023 in #ratos-support
Simple Filament Sensor ,
Hi I was searching and reading now a few days but i not realy found what i searching . I want to install a simple runout Sensor .
I found a lot for BTT and Orbiter sensor but nothing for an simple switch
What i want is a simple switch as sensor , if filament is running out he should go to a front parking position unload the filament and stay the bed heated .
after new filament in i hope on a conformation window if filament is back in if not than should repeat loading the filament .
all on the ratos based setup
what i understood so far was that i first have to setup the sensor
[filament_switch_sensor filament_sensor]
pause_on_runout: True
switch_pin: ^!PG11
I was d a lot about the macros
and the most creating than unload and loading macros but i not get why bec there are already macros for both does that ones are not working ?
sadly macros is still not my world
does anyone did something like that bevore and have some input for me ?
BR
Luchador
1 replies
RRCRat Rig Community [Unofficial]
•Created by Luchador on 5/1/2023 in #fix-my-printer
From BL touch to probe not working ?
4 replies
RRCRat Rig Community [Unofficial]
•Created by Luchador on 4/6/2023 in #fix-my-printer
Stepper Driver Port broken how to chang the Slot on Octopus F446
Hi, I just finished again a RatRig 400 but my Motors never run well .
After a lot tries and different steppers i get all running until one Motor , after trying switching Motors / drivers I tired the board also in an Running RatRig 300 with the same issue . So all looks like the Stepper driver Port is broken .
Next days will Test the board from the 300 in the 400 but so long i want to try to change the slot of the stepper Driver .
Does anyone tell me how to do it ?
BR
Thomas
26 replies