florinangeru
RRCRat Rig Community [Unofficial]
•Created by florinangeru on 1/23/2024 in #fix-my-printer
Y homming fails
yes, now it works perfectly 🙂
Thank you very much
24 replies
RRCRat Rig Community [Unofficial]
•Created by florinangeru on 1/23/2024 in #fix-my-printer
Y homming fails
from what I understand where the endstop is now is 0, and on the opposite side is 191. Shouldn't the y-axis go to 0 instead of going to 191?
24 replies
RRCRat Rig Community [Unofficial]
•Created by florinangeru on 1/23/2024 in #fix-my-printer
Y homming fails
at this moment if I run the command y home the Y axis does not move at all, the z axis goes down and then the error appears
24 replies
RRCRat Rig Community [Unofficial]
•Created by florinangeru on 1/23/2024 in #fix-my-printer
Y homming fails
24 replies
RRCRat Rig Community [Unofficial]
•Created by florinangeru on 1/23/2024 in #fix-my-printer
Y homming fails
yes, I think it's drop 15-20mm
24 replies
RRCRat Rig Community [Unofficial]
•Created by florinangeru on 1/23/2024 in #fix-my-printer
Y homming fails
this is the actual printer.cfg
24 replies
RRCRat Rig Community [Unofficial]
•Created by florinangeru on 1/23/2024 in #fix-my-printer
Y homming fails
24 replies
RRCRat Rig Community [Unofficial]
•Created by florinangeru on 1/23/2024 in #fix-my-printer
Y homming fails
24 replies
RRCRat Rig Community [Unofficial]
•Created by florinangeru on 1/23/2024 in #fix-my-printer
Y homming fails
24 replies
RRCRat Rig Community [Unofficial]
•Created by florinangeru on 1/23/2024 in #fix-my-printer
Y homming fails
thank you very much for clarifications 🙂
24 replies
RRCRat Rig Community [Unofficial]
•Created by florinangeru on 1/23/2024 in #fix-my-printer
Y homming fails
This is my situation
24 replies
RRCRat Rig Community [Unofficial]
•Created by florinangeru on 1/23/2024 in #fix-my-printer
Y homming fails
24 replies
RRCRat Rig Community [Unofficial]
•Created by florinangeru on 12/26/2023 in #ratos-support
Different screws for the Z axis
Thank you very much @miklschmidt . It's the first time I'm working with RatOs and I've seen many lines where it says "do not modify" and in order not to broke something I preferred to ask before.
5 replies