oazza.
RRCRat Rig Community [Unofficial]
•Created by oazza. on 2/18/2024 in #fix-my-printer
WHYYYYYYYYYYY
ok i got vcore 3 with the beacon 3d rev h probe... Ive done all the steps for the calibration including the Z_OFFSET_APPLY_PROBE and SAVE_CONFIG part of the beacon z probe . When i do my 1st print it goes fine. The issue arises when i do the exact same print again the bed ends up hitting the nozzle and scraps along the bed, so the calibrations now dose not work. so for some reason the setting are lost. The settings also don't save after i do a reboot...
5 replies