WHYYYYYYYYYYY

i got vcore 3 running ratos with beacon rev h..
issue after i do all the calibrations for the beacon ,then i do test print the 1st print does good then straight after the snd print it scrapes the bed ,, why the hell dose the bed keep hitting the bed...i don't get it. and when i do get it to work i do i reboot and the setting are not saved and im stuck having to repeat the process

DanO•2/18/24, 3:37 PM

Try explaining the problem again, your description isn’t clear.

pazza007OP•2/18/24, 10:31 PM

ok i got vcore 3 with the beacon 3d rev h probe... Ive done all the steps for the calibration including the Z_OFFSET_APPLY_PROBE and SAVE_CONFIG part of the beacon z probe . When i do my 1st print it goes fine. The issue arises when i do the exact same print again the bed ends up hitting the nozzle and scraps along the bed, so the calibrations now dose not work. so for some reason the setting are lost. The settings also don't save after i do a reboot...

printer2.cfg19.51KB

DanO•2/20/24, 3:24 AM

Try removing most of what you added as [beacon] in your printer.cfg it is already there with the beacon config include.