Andy
RRCRat Rig Community [Unofficial]
•Created by Andy on 4/21/2024 in #ratos-support
Error message
I got it working again commenting out the 10000 line. Thanks for the info I will change it tonight.
4 replies
RRCRat Rig Community [Unofficial]
•Created by Andy on 10/19/2023 in #ratos-support
ADXL
If possible I would like to use it with the firmware that it came with but the ratos configuration doesn't work.
4 replies
RRCRat Rig Community [Unofficial]
•Created by Andy on 9/23/2023 in #ratos-support
Nidec 4028 Fan
I have the tachometer working now. The issue was I had it connected to a fan header PD15. It is now connected to PG12 which is a 3 pin header and works perfectly.
5 replies
RRCRat Rig Community [Unofficial]
•Created by Andy on 9/27/2023 in #ratos-support
SuperPinda
I have the z probe working now thank you.👍
6 replies
RRCRat Rig Community [Unofficial]
•Created by Andy on 9/27/2023 in #ratos-support
SuperPinda
Thanks I will let you know how it goes.
6 replies
RRCRat Rig Community [Unofficial]
•Created by Andy on 9/27/2023 in #ratos-support
SuperPinda
I homed x and y then when I tried to home z I got the error. When I refresh the endstop list it shows as z and probe triggered.
6 replies
RRCRat Rig Community [Unofficial]
•Created by Andy on 9/23/2023 in #ratos-support
Nidec 4028 Fan
Thanks I will let you know when I have it sorted.
5 replies
RRCRat Rig Community [Unofficial]
•Created by Andy on 9/17/2023 in #ratos-support
Unable to parse option 'pid_Kd' in section 'heater_bed'.
Thank you for the help. That worked everything looks fine now.👏 👍
8 replies
RRCRat Rig Community [Unofficial]
•Created by Andy on 9/17/2023 in #ratos-support
Unable to parse option 'pid_Kd' in section 'heater_bed'.
Thank you i will try that later tonight.👍
8 replies
RRCRat Rig Community [Unofficial]
•Created by Andy on 9/17/2023 in #ratos-support
Unable to parse option 'pid_Kd' in section 'heater_bed'.
8 replies
RRCRat Rig Community [Unofficial]
•Created by Andy on 9/17/2023 in #ratos-support
Unable to parse option 'pid_Kd' in section 'heater_bed'.
I have added the klipper file as well, thanks.
8 replies