Andy
RRCRat Rig Community [Unofficial]
•Created by Andy on 4/21/2024 in #ratos-support
Error message
Just updated software and getting this error message. Option 'max_accel_to_decel' is not valid in section 'printer'. Checked the printer speed cfg and everything looks OK. Anyone else with the same issue?
4 replies
RRCRat Rig Community [Unofficial]
•Created by Andy on 10/19/2023 in #ratos-support
ADXL
I have a provok3d nozzle mounted ADXL345 board and I am looking for assistance to either flash it to klipper firmware or configure it in ratos.
4 replies
RRCRat Rig Community [Unofficial]
•Created by Andy on 9/27/2023 in #ratos-support
SuperPinda
M sensor is a SuperPindaI get an error when I home Z. Endstop z still triggered after retract. In the config all it says Probe Pin and I was thinking perhaps there should be more. Any help appreciated.
6 replies
RRCRat Rig Community [Unofficial]
•Created by Andy on 9/23/2023 in #ratos-support
Nidec 4028 Fan
I have a Nidec fan it is connected and working properly. The tachometer reading I get is always 0 RPM (in red) even when the fan is running. This is how I have it in my config. Have I missed something?
pin: !fan_part_cooling_pin cycle_time: 0.01 enable_pin: PA9 tachometer_pin: ^PD13 tachometer_poll_interval: 0.0005
pin: !fan_part_cooling_pin cycle_time: 0.01 enable_pin: PA9 tachometer_pin: ^PD13 tachometer_poll_interval: 0.0005
5 replies
RRCRat Rig Community [Unofficial]
•Created by Andy on 9/17/2023 in #ratos-support
Unable to parse option 'pid_Kd' in section 'heater_bed'.
8 replies