thekojent
RRCRat Rig Community [Unofficial]
•Created by thekojent on 9/3/2024 in #fix-my-printer
Unable to flash Octopus V1.1
Main thing for me was using RatOS 2.1, and using DFU for both boards. Good luck!
15 replies
RRCRat Rig Community [Unofficial]
•Created by thekojent on 9/3/2024 in #fix-my-printer
Unable to flash Octopus V1.1
15 replies
RRCRat Rig Community [Unofficial]
•Created by thekojent on 9/3/2024 in #fix-my-printer
Unable to flash Octopus V1.1
I also just realized I'm using RatOS 2.0.2, not 2.1. Retrying with 2.1, hopefully it goes smoother
15 replies
RRCRat Rig Community [Unofficial]
•Created by thekojent on 9/3/2024 in #fix-my-printer
Unable to flash Octopus V1.1
Interesting. Is there a way to tell in Mainsail if the board is detected (and the toolhead board too)?
15 replies
RRCRat Rig Community [Unofficial]
•Created by thekojent on 9/3/2024 in #fix-my-printer
Unable to flash Octopus V1.1
Correct - no error, just the "unresponsive" message after flashing
15 replies
RRCRat Rig Community [Unofficial]
•Created by thekojent on 9/3/2024 in #fix-my-printer
Unable to flash Octopus V1.1
SD card has zero issues writing to it, not sure if I have another SD card to try
Manually skipping the step works, but I'm not certain this solves the board not being flashed?
15 replies