absvinyl
RRCRat Rig Community [Unofficial]
•Created by absvinyl on 5/3/2024 in #ratos-support
V-Core3.1 with SKRAT & EBB42 wiring
What about the problem I'm having with ZMA and ZMB being wired in parallel on the board, "I'm having a problem with the Z motors. When I do, STEPPER_BUZZ STEPPER=stepper_z, both the left and rear Z motors move. Then with z1, the right motor moves. The z2, nothing moves.".... and even when everything is unplugged with no power, those two connections will still turn each other when one is manually turned.
16 replies
RRCRat Rig Community [Unofficial]
•Created by absvinyl on 5/3/2024 in #ratos-support
V-Core3.1 with SKRAT & EBB42 wiring
Is z0, z1, z2 supposed to be z left, z rear, z right?
16 replies
RRCRat Rig Community [Unofficial]
•Created by absvinyl on 5/3/2024 in #ratos-support
V-Core3.1 with SKRAT & EBB42 wiring
Seems on this board, the pins of ZMA and ZMB are wired in parallel. Just a faulty board?
16 replies
RRCRat Rig Community [Unofficial]
•Created by absvinyl on 5/3/2024 in #ratos-support
V-Core3.1 with SKRAT & EBB42 wiring
Ok, I found out that when there was no power to the printer or pi, when I manually rotate z0, both z0 and z1 would move. It seems that something on the board is shorting the connections for z0 and z1.
16 replies
RRCRat Rig Community [Unofficial]
•Created by absvinyl on 5/3/2024 in #ratos-support
V-Core3.1 with SKRAT & EBB42 wiring
16 replies
RRCRat Rig Community [Unofficial]
•Created by absvinyl on 5/3/2024 in #ratos-support
V-Core3.1 with SKRAT & EBB42 wiring
16 replies
RRCRat Rig Community [Unofficial]
•Created by absvinyl on 5/3/2024 in #ratos-support
V-Core3.1 with SKRAT & EBB42 wiring
I'm having a problem with the Z motors. When I do, STEPPER_BUZZ STEPPER=stepper_z, both the left and rear Z motors move. Then with z1, the right motor moves. The z2, nothing moves.
16 replies
RRCRat Rig Community [Unofficial]
•Created by absvinyl on 5/3/2024 in #ratos-support
V-Core3.1 with SKRAT & EBB42 wiring
Thank you for that, that helped a lot... One thing I don't understand from the pinout and config for the Toolboard, is what pins do I plug in the adxl345 to? I have the EBB42_1.2
16 replies