b33k
RRCRat Rig Community [Unofficial]
•Created by Maverik on 11/6/2023 in #ratos-support
Option 'control_pin' in section 'bltouch' must be specified while selecting pinda as probe
Thank you this old reply and sample saved me.
33 replies
RRCRat Rig Community [Unofficial]
•Created by b33k on 12/1/2022 in #fix-my-resonance
Resonance help for v-core 3 500
Yes, I am struggling to get good prints but it could be environmental as well. I’m in a cold garage. It’s that big 125hz spike that has me searching this route.
4 replies
RRCRat Rig Community [Unofficial]
•Created by b33k on 12/1/2022 in #ratos-support
Reboot failing
Thank you, I’ll do another fresh rebuild and see where I’m at.
7 replies
RRCRat Rig Community [Unofficial]
•Created by b33k on 12/1/2022 in #ratos-support
Reboot failing
Thanks, looking through it I see a bunch of KlipperScreen failures with a code=exited, status=1/FAILURE then it restarts and fails. I tried stopping that service manually and then rebooting and it didn’t reboot so idk.
I also see an error from crowsnest saying it doesn’t support setting of hardware encoding quality parameters.
7 replies