Retflux
RRCRat Rig Community [Unofficial]
•Created by Retflux on 3/15/2024 in #fix-my-print
pa12 cf15 after filament change mid print bad quality
The issue was the Nylon cf wasnt dry enough. After more then 24h drying it Prints Perfect again.
9 replies
RRCRat Rig Community [Unofficial]
•Created by Retflux on 3/15/2024 in #fix-my-print
pa12 cf15 after filament change mid print bad quality
9 replies
RRCRat Rig Community [Unofficial]
•Created by Retflux on 3/15/2024 in #fix-my-print
pa12 cf15 after filament change mid print bad quality
0.6 phaetus ph tungsten Carbide Nozzle.
I think this isnt the problem of this issue because it immediately happened after loading the new pool mid print
9 replies
RRCRat Rig Community [Unofficial]
•Created by Retflux on 10/30/2023 in #fix-my-print
esun epa cf Problem
Try it with other pa6 cf15 and same problem. I Set a new pressure advance and it’s still there.
7 replies
RRCRat Rig Community [Unofficial]
•Created by Retflux on 10/30/2023 in #fix-my-print
esun epa cf Problem
It’s still exist. I try different Flow, Temperatur and cooling no difference
7 replies
RRCRat Rig Community [Unofficial]
•Created by Retflux on 10/30/2023 in #fix-my-print
esun epa cf Problem
No with other Material Like pla cf, abs, pla there is no Problem. I get that rings only on esun Pa cf temperature i tested from 260 down to 240 and it still exist
7 replies