No0neinParticular
RRCRat Rig Community [Unofficial]
•Created by No0neinParticular on 2/20/2025 in #fix-my-printer
vcore 3.1 500 Bed Mesh
5 replies
RRCRat Rig Community [Unofficial]
•Created by No0neinParticular on 2/20/2025 in #fix-my-printer
vcore 3.1 500 Bed Mesh
So I don't have the enclosure pieces installed at the moment due to all the fiddling, but I did preheat the bedplate and loosened the gantry and adjusted as well as re-cleaned the PEI plate and carefully cleaned the magnetic surface. The results are better, but certainly not perfect. This bed has always had that wave in it. In the past I have completely disassembled it down to the last extrusion and reassembled and it remains so I think that it is an artifact of a not perfectly flat bed plate. Any other suggestions or is .158 close enough for most cases?
5 replies