invictuscockpits
RRCRat Rig Community [Unofficial]
•Created by invictuscockpits on 4/20/2024 in #fix-my-printer
Bed not heating
Yes, the fuses are good on both Octopus boards I’ve tried. Trying to heat through mainsail with both a standard heat to 60° c command and a PID tuning run. Beither activates the SSR.
14 replies
RRCRat Rig Community [Unofficial]
•Created by invictuscockpits on 4/20/2024 in #fix-my-printer
Bed not heating
Multimeter shows a connection on all wires. If I remove the bed heater wires from the terminals and connect a 12v power supply to the wires I took off them and the SSR switches on and the bed begins heating as expected. For some reason, the Octopus is not sending a signal to the SSR to turn on the heater.
14 replies
RRCRat Rig Community [Unofficial]
•Created by invictuscockpits on 4/20/2024 in #fix-my-printer
Bed not heating
14 replies
RRCRat Rig Community [Unofficial]
•Created by invictuscockpits on 4/20/2024 in #fix-my-printer
Bed not heating
Sorry, it took a minute to get back to the printer to download the config.
14 replies
RRCRat Rig Community [Unofficial]
•Created by invictuscockpits on 4/20/2024 in #fix-my-printer
Bed not heating
14 replies