ColinPartridge
RRCRat Rig Community [Unofficial]
•Created by ColinPartridge on 9/9/2024 in #fix-my-printer
Worn belts on VC 3.1 300mm
@blacksmithforlife 🇺🇸 I’ll have to look at that once I replace the belts, I can understand one belt wearing due to misalignment, but both? If that’s the case I need to look carefully at my build. Thanks.
8 replies
RRCRat Rig Community [Unofficial]
•Created by ColinPartridge on 9/9/2024 in #fix-my-printer
Worn belts on VC 3.1 300mm
@TheTik The resonant frequency of the belts is around 80hz, would that indicate they are too tight?
8 replies
RRCRat Rig Community [Unofficial]
•Created by ColinPartridge on 5/18/2024 in #fix-my-mesh
VC 3.1 300 first bed calibration.
That’s good to know, it’s taken along time to get to this point. Cheers
4 replies