julian
RRCRat Rig Community [Unofficial]
•Created by julian on 9/9/2024 in #ratos-support
RatOS 2.0 upgraded to v2.1.x - Custom V-Core 3.1 with Etched Foil bed heater w/ 3 combined sensors.
That’s a good point, and you’re right, I probably completely forgot about that part.
Thanks for the clarification @miklschmidt
8 replies
RRCRat Rig Community [Unofficial]
•Created by julian on 9/9/2024 in #ratos-support
RatOS 2.0 upgraded to v2.1.x - Custom V-Core 3.1 with Etched Foil bed heater w/ 3 combined sensors.
Thank you very much @blacksmithforlife, it worked perfect.
8 replies
RRCRat Rig Community [Unofficial]
•Created by julian on 9/9/2024 in #ratos-support
RatOS 2.0 upgraded to v2.1.x - Custom V-Core 3.1 with Etched Foil bed heater w/ 3 combined sensors.
This is basically the configuration I need to set:
[heater_bed]
heater_pin: PF5
max_power: 1
min_temp: 0
max_temp: 130
sensor_type: temperature_combined
sensor_list: temperature_sensor bed_bottom_1, temperature_sensor bed_bottom_2, temperature_sensor bed_top_1,
combination_method: min
maximum_deviation: 100
pwm_cycle_time: 0.02
[verify_heater heater_bed]
check_gain_time: 300 # Increased to allow more time for heat transfer
hysteresis: 10
max_error: 25 # Increased to allow for larger temperature differentials
[temperature_sensor bed_bottom_1]
sensor_type: ATC Semitec 104NT-4-R025H42G
sensor_pin: PB0
min_temp: 0
max_temp: 175
[temperature_sensor bed_bottom_2]
sensor_type: ATC Semitec 104NT-4-R025H42G
sensor_pin: PB1
min_temp: 0
max_temp: 175
[temperature_sensor bed_top_1]
sensor_type: ATC Semitec 104NT-4-R025H42G
sensor_pin: PC4
min_temp: 0
max_temp: 130
8 replies
RRCRat Rig Community [Unofficial]
•Created by Mr.Robot on 6/29/2023 in #fix-my-resonance
AWD enclosed VC 3.1 500 y belt tension issue
^500 but running Duet3D by the moment
27 replies