EternalPath
RRCRat Rig Community [Unofficial]
•Created by EternalPath on 12/23/2023 in #ratos-support
adaptive Mesh generating "move out of bounds" error when parts are close to the edge of the bed.
In ratos 2.0 with adaptive Mesh enabled.
If I put a part close to the edge of the bed.
I get a move out of bounds error during mesh probing.
Error doesn't occur with adaptive meshing disabled.
Presumably the probe point calculation is taking the probe offset into account, but not rounding to the bed limits.
17 replies
RRCRat Rig Community [Unofficial]
•Created by EternalPath on 10/23/2023 in #ratos-support
Adaptive Mesh KAMP and probe offsets
It looks like adaptive Mesh doesn't automatically subtract the probe offset?
In my setup the probe is at y+22mm so for a small print it doesn't probe the actual print area... Just the area next door.
2 replies
RRCRat Rig Community [Unofficial]
•Created by EternalPath on 10/11/2023 in #ratos-support
Ratos 2.0 update and copying printer config
Updating to ratos 2.0 by reflashing the sd card.
Can I just copy the contents of printer.cfg directly over into the printer.cfg in the new install?
Previous installation of ratos was the one just before the 2.0 release.
3 replies