BeardedCobra48
RRCRat Rig Community [Unofficial]
•Created by BeardedCobra48 on 3/2/2024 in #fix-my-printer
printer Smoking ☹
Hei there
I finished building a ratrig vcpre 3 500.
Now i am at installing it.
I did flash Rat OS to sd card of raspberry pi and turned on the printer to be able to connect to RatOS.
No sd card in Octopus v1.1 as of now!
While i was setzing up the wifi the printer started to smoke like crazy.
The hotend heater just heated like crazy without stopping! 😳
What am i doing wrong??
I checked the wiering and it seems to be correct.
268 replies
RRCRat Rig Community [Unofficial]
•Created by BeardedCobra48 on 3/20/2023 in #fix-my-print
BAD first Layer
Hey
I switched from a BLTouch to a Pinda on by VCore 3
I had some problems setting it up in the printer.config at first but due to the great helpe here it is running now.
But somehow it seeams to not make use of the measured first layer :/ i have a extreamly bad first layer :/ do i have to write some lines in my starting G-Code in the slicer or do i need to chang some other stats in the printer config? 😄
19 replies
RRCRat Rig Community [Unofficial]
•Created by BeardedCobra48 on 1/27/2023 in #fix-my-print
Tuning
22 replies