Macscott56
RRCRat Rig Community [Unofficial]
•Created by Macscott56 on 5/10/2024 in #fix-my-mesh
start G-code for PAM
I switched PCs and I'm trying to rebuild my Superslicer profile because I forgot to port it from the old PC. Can someone remind me what start Gcode to use when enabling PAM as part of the print sequence?
1 replies
RRCRat Rig Community [Unofficial]
•Created by Macscott56 on 6/2/2023 in #fix-my-printer
Clogged Nozzel?
13 replies
RRCRat Rig Community [Unofficial]
•Created by Macscott56 on 4/24/2023 in #fix-my-printer
Timing Pulley height
Does anyone have a good repeatable method for setting the X and Y stepper motor timing pulley heights?
Right now my process is to leave one of the set screws free, move the gantry back and forth, then adjust the timing pulley up or down depending if the belts moves up or down on the pulley.
Is there a more repeatable method for setting the height of the timing pulleys?
Thanks in advance.
2 replies
RRCRat Rig Community [Unofficial]
•Created by Macscott56 on 4/4/2023 in #fix-my-printer
Vertical ridges on circular prints and vibration.
20 replies