Bot Sculptor
RRCRat Rig Community [Unofficial]
•Created by Bot Sculptor on 4/26/2024 in #ratos-support
Cannot configure new board
I installed a new Octopus 446 control board and cannot get past the configuration. Wifi is good and I can bring up RatOs, but every time I click on "http://RatOS.local/configure?step=1" I get a 500 internal servor error.:" I flashed the board by SD card successfully, but still get stuck at the above link. Update: Pulled the Pi's SD card and started from scratch. Got the Pi configured fine and in the RatOs confiurator, but again, am stuck at flashing the firmware for the control board. I've tried automatically and manually with an SD card but still the same error that "Klipper doesn't seem to be running in your board...". Tried redoing it with another 446 board and got same results. Also tried with a 429 board and still got the same results. I've been searching trying for a week now with no luck. What am I doing wrong?
27 replies
RRCRat Rig Community [Unofficial]
•Created by Bot Sculptor on 4/25/2024 in #fix-my-printer
Can't install firmware on new board
I just replaced my Octopus 429 with a 446 and can't figure out how to flash the firmware on the new board. My Pi setup is still good and I have Mainsail up. The instructions direct me to http://ratos.local/configure?step=1# but all I get is a 500 internal server error.
3 replies
RRCRat Rig Community [Unofficial]
•Created by Bot Sculptor on 3/20/2024 in #fix-my-printer
PT1000 help needed
Trying to finish the install of the toolhead upgrade. I know I need to insert the code "[extruder]
sensor_type: PT1000" under User Overrides of the Printer.cfg. Did that but now getting a new error. Option 'control' in section 'heater_bed' must be specified
5 replies
RRCRat Rig Community [Unofficial]
•Created by Bot Sculptor on 3/5/2023 in #fix-my-printer
How to update firmware on Octopus 429?
I've been printing successfully for a while, and then after updated everything through the Update Manager, the bed heater stopped working and shuts down the printer after taking too long. Did a full diagnostic of all wires, connectors, resistance, etc and everything is solid and the SSR is getting power. My best guess was that I needed to update the firmware on my Octopus Pro 429, but all the links for how to do this lead to a dead page.
15 replies
RRCRat Rig Community [Unofficial]
•Created by Bot Sculptor on 12/4/2022 in #fix-my-printer
The build from Hell continues
This time I replaced the control board with a new Octopus 429 and replaced both SD cards with brand new ones and started the entire install from scratch. Got thru the initial config where I installed VCore Three config and then hit the brick wall again with "mcu unable to connect".
68 replies