Beluga
RRCRat Rig Community [Unofficial]
•Created by Beluga on 9/12/2023 in #ratos-support
quick question about prime blob(help please)
when the printer goes to the corner of the bed it always hits the frame, how do i modify the x,y coordinates so that it won't hit it?
5 replies
RRCRat Rig Community [Unofficial]
•Created by Beluga on 9/2/2023 in #ratos-support
Z offset problem
I can't calibrate the z-offset
If I use the PROBE-CALIBRATE comand then the bed doesn't go beyond a certain point(it goes up and come backs down) when using anything less than the -1 option like -0.1
If I use the z-offset section under toolhead
It # the bltouch offset and gives me an error saying the z-offset section must be specified
What to do?
22 replies
RRCRat Rig Community [Unofficial]
•Created by Beluga on 9/1/2023 in #ratos-support
extruder rotating in opposite direction
Hey guys my extruder is rotating the opposite way pushing the filament out
How do I invert this?
I couldn't find anything on the direction in the configs help thanks
3 replies
RRCRat Rig Community [Unofficial]
•Created by Beluga on 9/1/2023 in #ratos-support
I have a problem
41 replies
RRCRat Rig Community [Unofficial]
•Created by Beluga on 8/4/2023 in #ratos-support
need help with bltouch
at first the error was failed to verify sensor state after adding pin up reports not triggered false i get
failed to verify probe is raised the probe is deployed then goes back up and it gives me this error
i already tested the bltouch and it works the probe deploys when testing it(deployed) it says open when touching a piece of paper and triggered when not touching anything
help,thanks
19 replies