Sait17
RRCRat Rig Community [Unofficial]
•Created by Sait17 on 3/6/2025 in #ratos-support
Sample spread always too large
Yes, it is enabled. I will check everything again tomorrow and start from scratch, maybe I am overlooking something.
15 replies
RRCRat Rig Community [Unofficial]
•Created by Sait17 on 3/6/2025 in #ratos-support
Sample spread always too large
I also checked the problem, I tightened everything where it was heated up
15 replies
RRCRat Rig Community [Unofficial]
•Created by Sait17 on 3/6/2025 in #ratos-support
Sample spread always too large
This is annoying, as I haven't started a single print in days. Can't the value be changed or skipped ?
15 replies
RRCRat Rig Community [Unofficial]
•Created by Sait17 on 3/6/2025 in #ratos-support
Sample spread always too large
i have the 300, its selfsourced, But the Printplate, leadscrews and hardware kits were ordered directly from Ratrig. Only the aluminum parts were sourced separately, along with the rest of the components that Ratrig doesn't sell. However, I ordered all the parts exactly as required by the build.
15 replies
RRCRat Rig Community [Unofficial]
•Created by Sait17 on 3/6/2025 in #ratos-support
Sample spread always too large
Yes i have, I also let it heat up for more than fifteen minutes and started everything from scratch, but without success
15 replies
RRCRat Rig Community [Unofficial]
•Created by Sait17 on 1/8/2025 in #ratos-support
BTT manta m8p IDEX compatible
Thank you, I’ll think about how to best solve the problem
6 replies
RRCRat Rig Community [Unofficial]
•Created by Sait17 on 1/8/2025 in #ratos-support
BTT manta m8p IDEX compatible
Is it possible to use the two CAN ports on the board and the USB ports for VAOC and Beacon?
6 replies