Joao Barros Comments - Answer Overflow

Joao Barros

Posts Comments

RRCRat Rig Community [Unofficial]

•Created by constant-blue on 12/2/2022 in #ratos-support

Raspberry Pad 5 + CM4

I don't recall mine having that behavior

39 replies

RRCRat Rig Community [Unofficial]

•Created by ambitious-aqua on 8/7/2023 in #ratos-support

Duet 3 mini 5+

I’ve ran this board for months with RatOS and as @ptegler stated you just have to create the board pin definitions as the other boards. It will not flash automatically and that and an issue I discovered is the reason MK will not add it to the supported boards. The issue is when you power down the PSU and keep the Duet powered via USB (RPi) You have to reset the board/firmware or when you turn the PSU back on the drivers will uninitialized and in a high power state. Add a shared pin for all drivers and you can be homing an axis while the extruder driver is getting way too hot. I sold my Duet for the this reasons.

7 replies

RRCRat Rig Community [Unofficial]

•Created by ptegler on 3/15/2023 in #ratos-support

Measure_linear_vibrations_range ERROR!

Thanks, will test tonight 🙂

108 replies

RRCRat Rig Community [Unofficial]

•Created by ptegler on 3/15/2023 in #ratos-support

Measure_linear_vibrations_range ERROR!

If confirmation was needed, I'm being bitten by the same issue too

108 replies

RRCRat Rig Community [Unofficial]

•Created by underlying-yellow on 12/2/2022 in #ratos-support

Raspberry Pad 5 + CM4

A Pad5 You have some jumpers on the Pad5 you have to set in order to be able to write to the EMMC. You have to use the official Raspberry image writer. This is all documented in the Pad5 manual, don't know on other baseboards

39 replies

RRCRat Rig Community [Unofficial]

•Created by eastern-cyan on 12/2/2022 in #ratos-support

Raspberry Pad 5 + CM4

I have this running fine

39 replies

RRCRat Rig Community [Unofficial]

•Created by itchy-amethyst on 12/2/2022 in #ratos-support

Raspberry Pad 5 + CM4

Do you want me to wip something up?

39 replies

RRCRat Rig Community [Unofficial]

•Created by stormy-gold on 12/2/2022 in #ratos-support

Raspberry Pad 5 + CM4

@miklschmidt Maxx raised a point on minimum requirements for RatOS If you look at https://os.ratrig.com/docs/installation there's this minor mention of "(16GB or larger)." but I' believe this could be improved with a specific Minimum Requirements section to be clear and specific?

39 replies

RRCRat Rig Community [Unofficial]

•Created by quickest-silver on 12/2/2022 in #ratos-support

Raspberry Pad 5 + CM4

Indeed, 1GB is way more comfortable 🙂

39 replies

RRCRat Rig Community [Unofficial]

•Created by rare-sapphire on 12/2/2022 in #ratos-support

Raspberry Pad 5 + CM4

For the price of a CM4 I would not go that route and instead sell it (fast) hint hint @maxx6360 😉

39 replies

RRCRat Rig Community [Unofficial]