Xgc Deadwalker
RRCRat Rig Community [Unofficial]
•Created by Xgc Deadwalker on 12/29/2024 in #fix-my-printer
bed won’t heat
See the Verify the heater section
4 replies
RRCRat Rig Community [Unofficial]
•Created by Xgc Deadwalker on 7/30/2023 in #fix-my-printer
not sure what changed
8 replies
RRCRat Rig Community [Unofficial]
•Created by Xgc Deadwalker on 7/30/2023 in #fix-my-printer
not sure what changed
Ok so I did the home all then did the g0 command and it homes z then sets to 15 mm now it’s safe to say I need to lower my z offset and save it when I get paper to drag?
8 replies
RRCRat Rig Community [Unofficial]
•Created by Xgc Deadwalker on 7/30/2023 in #fix-my-printer
not sure what changed
How do I go about doing the z calibration? I’ve never figured that part out I’ve always just adjusted the zoffset but I thought this one was a little much
8 replies
RRCRat Rig Community [Unofficial]
•Created by Xgc Deadwalker on 7/9/2023 in #ratos-support
can’t upload anything
Not since trying to reflash the pi
5 replies
RRCRat Rig Community [Unofficial]
•Created by Xgc Deadwalker on 3/29/2023 in #fix-my-printer
can’t upload gcodes to my vcore3
Bump
4 replies
RRCRat Rig Community [Unofficial]
•Created by Xgc Deadwalker on 3/29/2023 in #fix-my-printer
can’t upload gcodes to my vcore3
Bump
4 replies
RRCRat Rig Community [Unofficial]
•Created by Xgc Deadwalker on 3/29/2023 in #fix-my-printer
can’t upload gcodes to my vcore3
I know it’s not a update issue as my printer is only hooked to wifi with no interweb
4 replies