susi1508
RRCRat Rig Community [Unofficial]
•Created by susi1508 on 7/4/2024 in #ratos-support
After Toolchange in Idex print Firmware restart
I See there are new gcode slicer configurations from Helge, will check this first. Thx mikl for this hint 👍
12 replies
RRCRat Rig Community [Unofficial]
•Created by susi1508 on 7/4/2024 in #ratos-support
After Toolchange in Idex print Firmware restart
I tried also PS, Same result
12 replies
RRCRat Rig Community [Unofficial]
•Created by susi1508 on 7/4/2024 in #ratos-support
After Toolchange in Idex print Firmware restart
12 replies
RRCRat Rig Community [Unofficial]
•Created by susi1508 on 7/4/2024 in #ratos-support
After Toolchange in Idex print Firmware restart
Tool change g-code
;tool change post processor tag
T[next_extruder] P1
12 replies
RRCRat Rig Community [Unofficial]
•Created by susi1508 on 7/4/2024 in #ratos-support
After Toolchange in Idex print Firmware restart
Will do when i am at home
12 replies