susi1508
RRCRat Rig Community [Unofficial]
•Created by susi1508 on 7/4/2024 in #ratos-support
After Toolchange in Idex print Firmware restart
Sorry but need help: IDEX 3.1 Manta M8P with EBB42 - RatOS 2.1. When i print with T0 standalone - everything works fine. When i print with T1 standalone everything works fine. When i make multicolorprint - after first switching to T1 it does purging and then start printing T1 - after a few sec rattling of extruder T1 lgx Lite Extruder gear (seems to overextrude) and klipper shutdown with
MCU 'toolboard_t1' shutdown: Rescheduled timer in the past
This generally occurs when the micro-controller has been
requested to step at a rate higher than it is capable of
obtaining.
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown
Sliced with SS (also the working standalone T0 and T1 prints) - what might be here the problem? Any suggestions?
Wrong Toolchange gcode in superslicer can cause this?
14 replies
RRCRat Rig Community [Unofficial]
•Created by susi1508 on 7/1/2024 in #ratos-support
RatOS 2.1.0 RC1 from 2024-06-21 - why does the RatOs Hotspot password raspberry don't work
only for explanation what i have done: fresh install on SD with balena etcher - RatOs HotSpot appears - when i want to connect over WLAN with Phone it asks for password - i used raspberry amd when i try to connect (authentication...) the error message "connection failed, PLease try again" and password window opens again... tried it with CM4 in an Manta M8P aand also with RPi4 - same behavior
3 replies