mabaul
RRCRat Rig Community [Unofficial]
•Created by mabaul on 10/28/2024 in #ratos-support
Getting IDEX to work
Thanks, but it's still the same
14 replies
RRCRat Rig Community [Unofficial]
•Created by mabaul on 10/28/2024 in #ratos-support
Getting IDEX to work
Is the position for the camera the same for both toolheads or is it saved under different variables?
14 replies
RRCRat Rig Community [Unofficial]
•Created by mabaul on 10/28/2024 in #ratos-support
Getting IDEX to work
14 replies
RRCRat Rig Community [Unofficial]
•Created by mabaul on 10/28/2024 in #ratos-support
Getting IDEX to work
I did the endstops, how Helge described it here https://discord.com/channels/582187371529764864/937654723727745046/1294658931699879968
14 replies
RRCRat Rig Community [Unofficial]
•Created by mabaul on 10/28/2024 in #ratos-support
Getting IDEX to work
I did the _VAOC_RESET, calibrated the endstops, and redid the VAOC. The second toolhead was like 10mm off from the camera. I calibrated and now the positions on the buildplate (nozzle and edge of buildplate) for T1 is not correct anymore. Is this normal?
14 replies
RRCRat Rig Community [Unofficial]
•Created by mabaul on 10/28/2024 in #ratos-support
Getting IDEX to work
Thanks, the update helped a bit, now i can at least get the VAOC done without an error message.
14 replies
RRCRat Rig Community [Unofficial]
•Created by mabaul on 10/28/2024 in #ratos-support
Getting IDEX to work
14 replies
RRCRat Rig Community [Unofficial]
•Created by mabaul on 10/28/2024 in #ratos-support
Getting IDEX to work
It seems there is some stuff messed up, when I start VAOC, the toolheads are some mm away from the camera. Also once started I can't stop VAOC without getting some Error
14 replies
RRCRat Rig Community [Unofficial]
•Created by mabaul on 10/28/2024 in #ratos-support
Getting IDEX to work
This is one after setting up Endstops and trying VAOC
14 replies
RRCRat Rig Community [Unofficial]
•Created by mabaul on 10/28/2024 in #ratos-support
Getting IDEX to work
14 replies