Getting IDEX to work

I started from a fresh install, after the old one kept spitting out errors. I am still getting just error messages and don't know what to do.
9 Replies
mabaul
mabaulOP4w ago
No description
mabaul
mabaulOP4w ago
This is one after setting up Endstops and trying VAOC It seems there is some stuff messed up, when I start VAOC, the toolheads are some mm away from the camera. Also once started I can't stop VAOC without getting some Error
ctbjdm_04135
ctbjdm_041354w ago
I can't directly help you, but saw this other day, same error: https://discord.com/channels/582187371529764864/1300179219606802522/1300199670257291294
mabaul
mabaulOP4w ago
Now I at least got to the point where i could do a z-offset but stopping VAOC i get some other error
No description
mabaul
mabaulOP4w ago
Thanks, the update helped a bit, now i can at least get the VAOC done without an error message. I did the _VAOC_RESET, calibrated the endstops, and redid the VAOC. The second toolhead was like 10mm off from the camera. I calibrated and now the positions on the buildplate (nozzle and edge of buildplate) for T1 is not correct anymore. Is this normal? I did the endstops, how Helge described it here https://discord.com/channels/582187371529764864/937654723727745046/1294658931699879968
mabaul
mabaulOP4w ago
When I start a print i get this error. I think something is not configured right or doesn't work right.
No description
mabaul
mabaulOP4w ago
Is the position for the camera the same for both toolheads or is it saved under different variables?
Helge Keck
Helge Keck4w ago
please update ratos and the configurator, run _VAOC_RESET and then try again
mabaul
mabaulOP4w ago
Thanks, but it's still the same
Want results from more Discord servers?
Add your server