petjek68
RRCRat Rig Community [Unofficial]
•Created by petjek68 on 4/23/2025 in #ratos-support
ratos-configurator.service stuck
I somehow solved it. Well, honestly I started from scratch and most but not everything went fine. At least I was able to finish the setup. But still struggeling with some minor issues.
6 replies
RRCRat Rig Community [Unofficial]
•Created by petjek68 on 4/23/2025 in #ratos-support
ratos-configurator.service stuck
I read about the doctor in the documentation troubleshooting section.
But:
pi@RatOS:~ $ ratos doctor
-bash: ratos: command not found
pi@RatOS:~ $
6 replies
RRCRat Rig Community [Unofficial]
•Created by petjek68 on 1/19/2023 in #fix-my-print
Overhanging issues
Well, I will but at the moment it even goes weirder. Yesterday I switched to a more standard hardened steel nozzle and the results are the same. Warps like hell too.
Never had this problem before. Printing temperatures are the same, cooling at 75% as before.
12 replies