Alosnah
RRCRat Rig Community [Unofficial]
•Created by PollePro on 9/12/2023 in #fix-my-printer
BIQU Microprobe
Got the Microprobe 2.0 working with Octopus 1.1 by wiring the 5v, GND and servo to the gpio on the Raspberry Pi instead of the contol board.
12 replies
RRCRat Rig Community [Unofficial]
•Created by fascinating-indigo on 10/17/2023 in #fix-my-printer
V-Minion Y-axis slipping
spreadCycle is the default I believe. Stealthchop is not part of the problem you are having if it is commented out.
8 replies
RRCRat Rig Community [Unofficial]
•Created by adverse-sapphire on 10/17/2023 in #fix-my-printer
V-Minion Y-axis slipping
Are you running the drivers in stealthchop mode? I solved the issue when turing back to spreadcycle mode.
8 replies