BIQU Microprobe
Hello,
I have bought a BIQU Microprobe to replace my BLTouch but when i connect it my MCU makes a Beeping sound and it makes a error.
It woks fine with the BLTouch and i use the same brand new cable for both? Any ideas?
11 Replies
MCU makes a Beeping soundthat is bad, it means you have something wired wrong and you are hurting your octopus board
Just cant seem to find the error. From what i can find the wiring from BLTouch and BIQU Microprobe should be the same?
what is the BIQU wiring diagram?
Seems like the same as BLTouch? I use a Octopus Pro f446
I tried to use this as a BLTouch but it will not work - did you get it to work?
No i bought a new BLTouch :/
Haha - me too!!! Just put it in and it works - so I guess just the wiring being the same is no reason to assume also the rest will be compatible (duh!)
Got the Microprobe 2.0 working with Octopus 1.1 by wiring the 5v, GND and servo to the gpio on the Raspberry Pi instead of the contol board.
Interesting! Thanks — will try at some point in the future I guess!
Yea from what i could see it it should be the same wiring but no.. 😛