Zeeflyboy
RRCRat Rig Community [Unofficial]
•Created by Zeeflyboy on 9/21/2024 in #ratos-support
octopus pro detected but not responding
Hi, just wondered if anyone had any suggestions for me - printer had been working fine last time I used it.
I went to use it recently and got “Moonraker can't connect to Klipper!
Please check if the Klipper service is running and klippy_uds_address is correctly configured in the moonraker.conf.”
On troubleshooting this, I tried reinstalling klipper on my octopus pro 446… when I go through the configurator it detects the board fine, but after trying to check version it tells me “octopus pro 446 detected but is unresponsive”.
I tried resetting, depowering and repowering etc. I’ve tried automatically reflashing the firmware, I’ve put the board into DFU which gets detected fine and then flashed the firmware. Nothing appears to have helped though as the board remains unresponsive. I haven’t made any changes to setup or wiring etc.
Any ideas or has the board just randomly died?
11 replies
RRCRat Rig Community [Unofficial]
•Created by Zeeflyboy on 8/22/2023 in #ratos-support
connectivity issues
3 replies