dead_again
RRCRat Rig Community [Unofficial]
•Created by dead_again on 12/9/2024 in #fix-my-print
first layer keeps getting worse while it’s printing
After trying to figure out the origin of the issue I ended up focusing on the gantry. The 2020 extrusion when it gets hot it expands and due the nut holding it in place it doesn’t have any space so it bends towards to bed. So I heated the printer for like 3 hours and I unscrewed the T nut so it can expand. I saw some improvement but not perfect
40 replies
RRCRat Rig Community [Unofficial]
•Created by dead_again on 12/9/2024 in #fix-my-print
first layer keeps getting worse while it’s printing
Not much of a difference!! But thanks for your help
40 replies
RRCRat Rig Community [Unofficial]
•Created by dead_again on 12/9/2024 in #fix-my-print
first layer keeps getting worse while it’s printing
Yes i have tried to adjust the knob but didn’t pay much attention to it will try again
40 replies
RRCRat Rig Community [Unofficial]
•Created by dead_again on 12/9/2024 in #fix-my-print
first layer keeps getting worse while it’s printing
40 replies
RRCRat Rig Community [Unofficial]
•Created by dead_again on 12/9/2024 in #fix-my-print
first layer keeps getting worse while it’s printing
It’s very strange because it doesn’t seems like a bed levelling issue but more of a over extrusion since I noticed that when I print large items the perimeter is perfect and the first few first layer paths and then it start going crazy. Also if I change the feed rate when the wavy pattern start the I get a very good layer but for only a few paths of the infill
40 replies
RRCRat Rig Community [Unofficial]
•Created by dead_again on 12/9/2024 in #fix-my-print
first layer keeps getting worse while it’s printing
I have already added that to my printer cfg nothing changes
40 replies
RRCRat Rig Community [Unofficial]
•Created by dead_again on 12/9/2024 in #fix-my-print
first layer keeps getting worse while it’s printing
Just checked not much of a difference
40 replies
RRCRat Rig Community [Unofficial]
•Created by dead_again on 12/9/2024 in #fix-my-print
first layer keeps getting worse while it’s printing
Thanks for you attached link I will check tomorrow
40 replies