polyhedra_
RRCRat Rig Community [Unofficial]
•Created by Daxxer on 4/11/2024 in #fix-my-mesh
VC3.1 500. From Saddle to bow
I'm still pushing the idea of bent rails/extrusion as I had a similar bed mesh on my VC400 once
also you had quite a radical shift of a mesh compared to the first one you posted
16 replies
RRCRat Rig Community [Unofficial]
•Created by Daxxer on 4/11/2024 in #fix-my-mesh
VC3.1 500. From Saddle to bow
I would make sure that Y alu extrusions aren't under tension that would cause them to bend, also try to loosen the Y linear rails so that they stay in place (idea is to see if giving them some wiggle room/releasing any potential tension will make your mesh any better)
16 replies
RRCRat Rig Community [Unofficial]
•Created by Daxxer on 4/11/2024 in #fix-my-mesh
VC3.1 500. From Saddle to bow
16 replies
RRCRat Rig Community [Unofficial]
•Created by Daxxer on 4/11/2024 in #fix-my-mesh
VC3.1 500. From Saddle to bow
are you sure that your linear rails are bolted together to the frame properly ? to me it kinda looks likethey might have loosened over time or something, the pattern you can see here suggests your gantry is bent and that is most likely uneven tension on the linear rail, just be sure that you read the graph properly!
16 replies