asincity
asincity
RRCRat Rig Community [Unofficial]
Created by asincity on 11/24/2024 in #ratos-support
Hold_current
Thanks for your help. I got the fix. You gave me a good direction to go with. I started testing the pins and notice something with the motor. I didn't have the allan key screws tight enough on the motor and the pulley was slipping. Thanks
32 replies
RRCRat Rig Community [Unofficial]
Created by asincity on 11/24/2024 in #ratos-support
Hold_current
I will go down that path and check the pins first. I will let you know what I find. Thanks for your help.
32 replies
RRCRat Rig Community [Unofficial]
Created by asincity on 11/24/2024 in #ratos-support
Hold_current
I will check all of the pins make sure one did not pop out.
32 replies
RRCRat Rig Community [Unofficial]
Created by asincity on 11/24/2024 in #ratos-support
Hold_current
And right now I have the belts loose. As I was trying that way after I tightedned them.
32 replies
RRCRat Rig Community [Unofficial]
Created by asincity on 11/24/2024 in #ratos-support
Hold_current
Yeah pretty much. It doesn't take much to hold it.
32 replies
RRCRat Rig Community [Unofficial]
Created by asincity on 11/24/2024 in #ratos-support
Hold_current
32 replies
RRCRat Rig Community [Unofficial]
Created by asincity on 11/24/2024 in #ratos-support
Hold_current
Yeap I did that
32 replies
RRCRat Rig Community [Unofficial]
Created by asincity on 11/24/2024 in #ratos-support
Hold_current
Give me a minute and I will fire it back up and get a video.
32 replies
RRCRat Rig Community [Unofficial]
Created by asincity on 11/24/2024 in #ratos-support
Hold_current
I did also loosen up the rails and move it back and forth trying to make sure they are parrell.
32 replies
RRCRat Rig Community [Unofficial]
Created by asincity on 11/24/2024 in #ratos-support
Hold_current
I just did the install of RatOs and fired it up. I haven't changed anything else yet.
32 replies
RRCRat Rig Community [Unofficial]
Created by asincity on 11/24/2024 in #ratos-support
Hold_current
No this is an V core 3 upgraded to a v core 3.1
32 replies
RRCRat Rig Community [Unofficial]
Created by asincity on 11/24/2024 in #ratos-support
Hold_current
When I home either x or y axis. The other axis moves some. So if you just home x . It moves some on the y axis instead of staying still. It does the exact oppisite if I just home y. I though belt tension but I tried both loosing and tightened belts with no change.
32 replies
RRCRat Rig Community [Unofficial]
Created by asincity on 11/24/2024 in #ratos-support
Hold_current
Thank you for the information. I was trying to troubleshoot an issue. I thought it might be realted to hold current not in the RatOs. Since it is not an issue. I wll keep looking elsewhere.
32 replies