nocjef
RRCRat Rig Community [Unofficial]
•Created by nocjef on 12/31/2024 in #ratos-support
Do I need to do anything special in ratos 2.1 for a 4028 fan?
I’ve recently upgraded to 2.1.0rc3 and want to add a 4028 part cooling fan. I’m currently using dual 5015 fans and would like something a bit stronger.
Other than the wiring which is covered in the build guide, will I still need to adjust my printer.cfg as such [fan] pin: !fan_part_cooling_pin cycle_time: 0.01 enable_pin: PA9 #using this pin as example Does this need to be added before i install the fan? I had bad luck wiring up my last 4028 and fried it 😦
Other than the wiring which is covered in the build guide, will I still need to adjust my printer.cfg as such [fan] pin: !fan_part_cooling_pin cycle_time: 0.01 enable_pin: PA9 #using this pin as example Does this need to be added before i install the fan? I had bad luck wiring up my last 4028 and fried it 😦
3 replies
RRCRat Rig Community [Unofficial]
•Created by nocjef on 2/21/2023 in #fix-my-mesh
500mm v-core 3 (enclosed). Can I do better?
14 replies