F3llwurst
RRCRat Rig Community [Unofficial]
•Created by K2theStank 🇨🇦 on 3/6/2025 in #fix-my-printer
Why is my Z-Tilt only hitting 2 of 3 corners
Ok. Thank you👍
17 replies
RRCRat Rig Community [Unofficial]
•Created by K2theStank 🇨🇦 on 3/6/2025 in #fix-my-printer
Why is my Z-Tilt only hitting 2 of 3 corners
Do i have to repeat the previous steps?
17 replies
RRCRat Rig Community [Unofficial]
•Created by K2theStank 🇨🇦 on 3/6/2025 in #fix-my-printer
Why is my Z-Tilt only hitting 2 of 3 corners
OMG 🤦 misunderstood something. Thank you
17 replies
RRCRat Rig Community [Unofficial]
•Created by K2theStank 🇨🇦 on 3/6/2025 in #fix-my-printer
Why is my Z-Tilt only hitting 2 of 3 corners
No. My top y-belts are not installed ( com-guide tells so). The other belts are looking fine.
17 replies
RRCRat Rig Community [Unofficial]
•Created by K2theStank 🇨🇦 on 3/6/2025 in #fix-my-printer
Why is my Z-Tilt only hitting 2 of 3 corners
i have the same problem. when i turn off performance mode everything works fine. should i finish the commissioning without performance mode and see if it works when commissioning is finished?
17 replies