Ibot
RRCRat Rig Community [Unofficial]
•Created by Ibot on 12/21/2024 in #ratos-support
Octopus HE0 & HE1 (PA2, PA3) always on
I just finished my Vcore 4 a few days ago. RatOS works amazingly so far. I’m only unable to figure out one thing:
I use the VC in Idex mode with stock electronics. I wired the power of T0 and T1 to the heater ports on the octopus. My goal is to add the mosfets of the heater ports as an output pin to my config. This way I can toggle the power adding another layer of securing during a shutdown if something went wrong with my toolhead boards.
But my issue is that for some reason both ports are turned on all the time and I’m unable to find the reason why. Checked the config but I can’t find any section where PA2 and PA3 from the octopus are defined.
2 replies