craftycooky
RRCRat Rig Community [Unofficial]
•Created by craftycooky on 3/12/2024 in #fix-my-printer
Delta Fan not turning off at 0%.
I'm closing this thread until I get a new 4028 unless anybody has an idea what my original mistake was.
14 replies
RRCRat Rig Community [Unofficial]
•Created by craftycooky on 3/12/2024 in #fix-my-printer
Delta Fan not turning off at 0%.
Everything is working on the board just not the fan
14 replies
RRCRat Rig Community [Unofficial]
•Created by craftycooky on 3/12/2024 in #fix-my-printer
Delta Fan not turning off at 0%.
Board can't be fried by that can it?
14 replies
RRCRat Rig Community [Unofficial]
•Created by craftycooky on 3/12/2024 in #fix-my-printer
Delta Fan not turning off at 0%.
Alright.. After recrimping the pwd wire I accidentally connected it to the 12v pin of the board so I think I fried the fan
14 replies
RRCRat Rig Community [Unofficial]
•Created by craftycooky on 3/12/2024 in #fix-my-printer
Delta Fan not turning off at 0%.
I'm going to recrimp the pmd wire. It behaves the exact same while it's pluggin in or out
14 replies
RRCRat Rig Community [Unofficial]
•Created by craftycooky on 3/12/2024 in #fix-my-printer
Delta Fan not turning off at 0%.
I can't move it to the right. It's the part cooling fan of which I don't have a tacho installed.
14 replies
RRCRat Rig Community [Unofficial]
•Created by craftycooky on 3/12/2024 in #fix-my-printer
Delta Fan not turning off at 0%.
Same result but the fan is at a higher RPM whilst stating that it's at 0 procent in the dashboard. I'm a little bit lost thb
14 replies
RRCRat Rig Community [Unofficial]
•Created by craftycooky on 3/12/2024 in #fix-my-printer
Delta Fan not turning off at 0%.
14 replies
RRCRat Rig Community [Unofficial]
•Created by craftycooky on 2/17/2024 in #fix-my-printer
IDM configuration troubles - 'Move out of range: 20.000 -7.000 2.000 [0.000]
Thanks.. I'v managed to solve this adjusting the mesh_min setting as you advised
9 replies