IDM configuration troubles - 'Move out of range: 20.000 -7.000 2.000 [0.000]
I am having some trouble setting up my IDM bed mesh sensor. When i want to start a bed mesh I get the following message 'Move out of range: 20.000 -7.000 2.000 [0.000]. What do i need to adjust for it to ignore this range?
5 Replies
My beacon did the same. You need to adjust your mesh_min setting.
Thanks.. I'v managed to solve this adjusting the mesh_min setting as you advised
How do you do this and what should I set it too? Same error.
[bed_mesh]
speed: 500
mesh_min: 10, 17
mesh_max: 490, 490
probe_count: 50, 50
You may need to adjust yours. I have a 500 and a custom head.
I just reloaded ratos on my 500 and i have nothing like this in my old config but this on is giving me the same error as stated here. only thing i have done is getting setup for my 5160T at 48v. Can someone tell me where this error comes from and what the numbers mean so i can understand what is going on. Thanks
and with the changes from above me now my error is 10.000 -10.000 2.000 [0.000] now for the move out of range???
got it fixed had to input the offset of the fan duct i was using