flyingonion
RRCRat Rig Community [Unofficial]
•Created by flyingonion on 8/19/2023 in #fix-my-printer
Heater issue: Heater extruder not heating at expected rate
15 replies
RRCRat Rig Community [Unofficial]
•Created by flyingonion on 3/15/2023 in #fix-my-mesh
Bed mesh not working correctly
5 replies
RRCRat Rig Community [Unofficial]
•Created by flyingonion on 3/12/2023 in #fix-my-printer
Z Tilt always failing: Probed points range is increasing
Hi. I've just finished with the assembly of a V-Core 3.1 300 (standard kit, everything bought from RatRig store) and I haven't been able to get the Z Tilt working consistently.
A couple of times it worked and seemed to be fine, but upon starting a print and checking again Z tilt it started failing.
I have the standard V Core 3.1 printer cfg in Klipper, with minor adjustments to the Super Pinda probe z offset.
I'm a bit lost on this. What should I start checking for this?
Thanks! 😄
3 replies