Maruba
RRCRat Rig Community [Unofficial]
•Created by Maruba on 6/19/2024 in #ratos-support
Strange Minion Behavior after Update 2.1
With a new cable, homings works fine now.
17 replies
RRCRat Rig Community [Unofficial]
•Created by Maruba on 6/19/2024 in #ratos-support
Strange Minion Behavior after Update 2.1
@MDFPereira i chamged the cables. I lt might Work now, will Check tonight If anything Runs smoothly.
17 replies
RRCRat Rig Community [Unofficial]
•Created by Maruba on 6/19/2024 in #ratos-support
Strange Minion Behavior after Update 2.1
I will check again. it is connected to my octopus.
17 replies
RRCRat Rig Community [Unofficial]
•Created by Maruba on 6/19/2024 in #ratos-support
Strange Minion Behavior after Update 2.1
X Endstop is always triggered. I tried a new Endstop, same Issue. If i push it manually status does not change
17 replies
RRCRat Rig Community [Unofficial]
•Created by Maruba on 6/19/2024 in #ratos-support
Strange Minion Behavior after Update 2.1
Here is the old one. It has the same value. Also x does not Home with out homing_retract_dist. if i set this value to 5 it says Endstop x still triggered after retract. Value 0 moves the Toolhead but it does go to the trigger point
17 replies
RRCRat Rig Community [Unofficial]
•Created by Maruba on 6/19/2024 in #ratos-support
Strange Minion Behavior after Update 2.1
@MDFPereira thank you, i will Check it tonight.
17 replies
RRCRat Rig Community [Unofficial]
•Created by Maruba on 3/29/2024 in #german-support
komisch Linie beim Druck mit Minion
@Pinky aka 3D Druckerplausch danke nochmal. Gestern neu gefettet und noch mal die leadscrew neu ausgerichtet
5 replies
RRCRat Rig Community [Unofficial]
•Created by Maruba on 3/29/2024 in #german-support
komisch Linie beim Druck mit Minion
Hi Danke dir werde ich nachher direkt in Angriff nehmen
5 replies