Strange Minion Behavior after Update 2.1
Hi there guys. I have some issues after upgrading to 2.1. My minion is not homing correctly on X and it also moves in the wrong direction when performing a bed Mesh and also out of the bed. I put on a video and a picture of my config. Also my debug.zip . Hope someone can help me out here
11 Replies
Your position_min on X is not correct.
Check what value you had on 2.0 and correct on 2.1
@MDFPereira thank you, i will Check it tonight.
Here is the old one. It has the same value. Also x does not Home with out homing_retract_dist. if i set this value to 5 it says Endstop x still triggered after retract. Value 0 moves the Toolhead but it does go to the trigger point
X Endstop is always triggered. I tried a new Endstop, same Issue. If i push it manually status does not change
check if it is wired in the correct port.
do you have it on the toolboard or mainboard?
a missing signal (not connected) endstop will always show as triggered
I will check again. it is connected to my octopus.
make sure on configurator you select your octopus
@MDFPereira i chamged the cables. I lt might Work now, will Check tonight If anything Runs smoothly.
Hope so 😉
Solution
With a new cable, homings works fine now.
Nice…