Gabbajoe
RRCRat Rig Community [Unofficial]
•Created by chrisforce on 2/21/2024 in #fix-my-print
Umbau sensorless auf Endstop probleme
wenn du die endstops drueckst stehen die immer noch auf triggered? Wenn ja klingt nach verpolt und du hast deien endstop port gekillt.
3 replies
RRCRat Rig Community [Unofficial]
•Created by phongshader on 2/11/2024 in #fix-my-printer
orbiter filament sensor setup?
hi check this config out https://discord.com/channels/582187371529764864/1165332949806366802/1165362061832880228 works for me like a charm.
5 replies
RRCRat Rig Community [Unofficial]
•Created by lillian on 2/12/2024 in #fix-my-printer
ERROR c0130010
this looks like a wiring issue check you x/y motor connectors if one pin is lose.
14 replies
RRCRat Rig Community [Unofficial]
•Created by K1ear on 2/17/2024 in #fix-my-printer
X and Y motor axis confused even after swapping wires on mainboard
Check the endstop state on your machine tab and double check your wiring of the endstop. I killed with a incorrect wiring one of my endstop ports because I did not pay attention. See the pinout for the endstop here https://discord.com/channels/582187371529764864/791048619997659176/1207768018969427998.
If the endstop port is dead it will be always triggered and you have to use a new port.
To do so you have then to provide the new endstop port pin for the y axes in you overwrite section in your printer.cfg here a example:
Good luck.
16 replies