DollaTom
RRCRat Rig Community [Unofficial]
•Created by DollaTom on 3/10/2023 in #ratos-support
Flash stock - Extruder not heating at expected rate
Hey guys, I need to flash the backup .hex of my stock firmware back to my MK3S+, I've been getting a heater not heating at expected rate error, and generally things have been very unpredictable and bizarre after switching from calibrating PLA to PETG. Is there an easy way to load this .hex back onto my board?
15 replies
RRCRat Rig Community [Unofficial]
•Created by DollaTom on 3/10/2023 in #ratos-support
Support for Prusa MK3S+
Original request raised in #ratos-development Big thanks to Mikl and blacksmith for chiming in - https://discord.com/channels/582187371529764864/859890291591217162/1082791496295653386
Unfortunately I'm not familiar enough with this project to speculate on the processes involved here but I can give my user report.
Setting up a Raspberry Pi 3b+ with RatOS v2.x: v2.0.0-10-g440096b
Had to force skip configurator due to no board detection, ran updates as described in docs, and then ran the INSTALL_PRUSA_MK3S command in console
Klipper started attempting to connect
1 replies
RRCRat Rig Community [Unofficial]
•Created by DollaTom on 3/8/2023 in #ratos-support
Support for Prusa MK3S+
308 replies