Marv
RRCRat Rig Community [Unofficial]
•Created by Marv on 12/15/2024 in #ratos-support
MCU Protocol error (version mismatch)
6 replies
RRCRat Rig Community [Unofficial]
•Created by Marv on 9/23/2023 in #ratos-support
Acceleration does not change from first layer accel.
Hi, running a v0.2 on RatOS v2.0.0-53. Acceleration for first layer is set to 1500 in the slicer, normal print accelleration something much higher. gcode also tells the printer to use a different acceleration yet it doesn't take it and wants to continue at 1500.
7 replies
RRCRat Rig Community [Unofficial]
•Created by Marv on 4/28/2023 in #ratos-support
BED_SCREWS_ADJUST missing
Can't seem to use the BED_SCREWS_ADJUST command in the klipper documentation. Was it removed from RatOS?
2 replies
RRCRat Rig Community [Unofficial]
•Created by Marv on 3/11/2023 in #ratos-support
RatOS with WiFi dongle
Has anyone ever gotten a wifi dongle working with ratos running on a pi? I got a basic 802.11n dongle plugged in a pi2b with ratos2.0 32bit but it does not want to connect.
When using a fresh ratos install it does not create a wifi network.
any clues?
19 replies
RRCRat Rig Community [Unofficial]
•Created by Marv on 3/9/2023 in #ratos-support
skr mini e3 v3 ratos 2.0 flashing issues
Trying to flash ratos 2.0 on the board. steps:
ratos config page
select mini e3 v3
compile fw
download firmware.bin
format 128mb sd to FAT
move firmware.bin to sd
plug into (powered) board
fast blinking status led
status led off for a second or so
slow blinking status LED
unplug SD
sd needs to be formatted to be read by windows
ratos does not recognise the board over usb
anyone got a clue? The board has nothing plugged into it except for power, usb and the jumpers for sensorless homing
7 replies
RRCRat Rig Community [Unofficial]
•Created by Marv on 1/3/2023 in #ratos-support
Timer too close after every print
Heya, seems like i recently started getting the issue of my printer after every print. the print finishes fine, toolhead parks in the back but then i get the error
37 replies