jb02877
RRCRat Rig Community [Unofficial]
•Created by jb02877 on 10/25/2024 in #fix-my-printer
How do I stop END_PRINT from calling M84?
Everytime the print ends, my heavy bed gets misaligned. I want to temporarily resolve this issue by stopping the end print macro from calling the M84 command. How do i do this in the config file?
3 replies
RRCRat Rig Community [Unofficial]
•Created by jb02877 on 9/20/2024 in #fix-my-printer
Temperature Wait issue
After I finish printing at 220C and i want to print again, the web interface waits for the hotend to cool down to 150C before it heats it up again to target temp of 220C. Seems like a waste of time for it to cool to 150 just to heat it back up again. How do i tell rat os to skip waiting for 150C and just go ahead an heat it back to 220?
6 replies
RRCRat Rig Community [Unofficial]
•Created by jb02877 on 9/17/2024 in #fix-my-printer
Can I use a creality adxl345 accelerometer for my DIY ratrig 4?
11 replies
RRCRat Rig Community [Unofficial]
•Created by jb02877 on 9/7/2024 in #fix-my-printer
Sensorless Homing Problem with TMC5160 and BTT Octopus 1.1 F407 board
Used setup wizard and entered tmc 5160 as X and Y stepper driver
Set voltage to 24V
Set set to sensorless homing
What I done so far:
Verified that both are using virtual endstops
Both x and y sensorless homing cofigs set to diag0 pins
Set SGT to -64
Set current to 0.3amps
Sensorless homing still doesnt work and toolhead just rams into frame until I get an overheat error
Spent 2 days researching and nothing works
What am i missing?
4 replies