GleasonRyan
AAE📼 Addie’s Analog Emporium 🌐
•Created by GleasonRyan on 6/30/2024 in #tech-help
Encoder Overload while using Aitum Vertical
It doesnt, ive tried disabling both previews and no luck
19 replies
AAE📼 Addie’s Analog Emporium 🌐
•Created by GleasonRyan on 6/30/2024 in #tech-help
Encoder Overload while using Aitum Vertical
Think I finally got Killer gone and ran a test, nothing for 58 minutes thought it was all good and then boom :dead_inside:
19 replies
AAE📼 Addie’s Analog Emporium 🌐
•Created by GleasonRyan on 6/30/2024 in #tech-help
Encoder Overload while using Aitum Vertical
Ive went in and unisntalled and and just installed with the hardware drivers like it mentions but for some reason it keeps showing up. I do think it would just impact over the network stuff though like you mentioned
19 replies
AAE📼 Addie’s Analog Emporium 🌐
•Created by GleasonRyan on 6/30/2024 in #tech-help
Encoder Overload while using Aitum Vertical
Yeah ive posted there, but they're out for twitchcon so was just bouncing off others here. I know its not a lot of skipped/missed frames but its super noticeable on stream/recording and its just odd the encoder sits at well under peak the whole time, then it spikes and causes this issue. Gonna try maybe going to an older version and run some more tests
19 replies
AAE📼 Addie’s Analog Emporium 🌐
•Created by GleasonRyan on 6/30/2024 in #tech-help
Encoder Overload while using Aitum Vertical
Even on the lowest preset for recording it happened around the hour mark. It consistently happens around that hour mark, it can happen before but it usually always happens around an hour, thats the only real consistent ive found
https://obsproject.com/logs/Qk2BsOQ8HjhefORy
19 replies
AAE📼 Addie’s Analog Emporium 🌐
•Created by GleasonRyan on 6/30/2024 in #tech-help
Encoder Overload while using Aitum Vertical
is recording vertical more intesne than source recording on top of streaming and recording main canvas? I had done another test with no vertical while streaming and recording main canvas and source recording three of my sources without any overloading
19 replies
AAE📼 Addie’s Analog Emporium 🌐
•Created by GleasonRyan on 6/30/2024 in #tech-help
Encoder Overload while using Aitum Vertical
ive gone as low as medium in previous tests, which I feel SHOULD be enough, but when im done with this current test Ill run another with fastest just to check
19 replies