Maarten
RRCRat Rig Community [Unofficial]
•Created by Maarten on 10/6/2023 in #fix-my-printer
Every now and then Stepper_z1 doesn't enable properly.
Good tip on the screw terminals, I'll check those when I redo the crimp later tonight
11 replies
RRCRat Rig Community [Unofficial]
•Created by Maarten on 10/6/2023 in #fix-my-printer
Every now and then Stepper_z1 doesn't enable properly.
thanks for the info! I did crimp all the other connectors correctly but I think this one must have snuck through my quality assurance. Calling it a case of the mondays
11 replies
RRCRat Rig Community [Unofficial]
•Created by Maarten on 10/6/2023 in #fix-my-printer
Every now and then Stepper_z1 doesn't enable properly.
yesterday I got a Z1 overheat warning and saw this when investigating
11 replies
RRCRat Rig Community [Unofficial]
•Created by Maarten on 10/6/2023 in #fix-my-printer
Every now and then Stepper_z1 doesn't enable properly.
Thanks dude, at the time I looked at it, nothing looked wrong and the cables all felt the same, so I was headstrong and kept using it
11 replies
RRCRat Rig Community [Unofficial]
•Created by Maarten on 10/6/2023 in #fix-my-printer
Every now and then Stepper_z1 doesn't enable properly.
in my defense, at the time it looked fine and kept working until yesterday
11 replies
RRCRat Rig Community [Unofficial]
•Created by Maarten on 10/6/2023 in #fix-my-printer
Every now and then Stepper_z1 doesn't enable properly.
@VisualTech48 you were right https://i.imgur.com/gFEKqjE.jpg
11 replies
RRCRat Rig Community [Unofficial]
•Created by Maarten on 8/30/2023 in #fix-my-printer
Heatsoak with mosquito magnum on EVA 2.4
you absolute genius, I think the jumper was set to 12V from the factory
3 replies