Maarten
RRCRat Rig Community [Unofficial]
•Created by Maarten on 10/6/2023 in #fix-my-printer
Every now and then Stepper_z1 doesn't enable properly.
As the title says. From time to time my printer doesn't enable z1 properly when it should be. Instead making an awful noise and not moving(a lot) while homing.
This issue will persist between turning the printer off and on again but can be resolved(semi permanently) by enabling the z steppers manually and then homing. Next time it's turned on it will work flawlessly again for weeks/months.
Anybody have an idea of what's causing this? Should I just enable the z steppers when turning the printer on and forget the issue existed?
11 replies
RRCRat Rig Community [Unofficial]
•Created by Maarten on 8/30/2023 in #fix-my-printer
Heatsoak with mosquito magnum on EVA 2.4
Hi guys,
I'm getting heatsoak printing slow solid infills with my setup and am wondering if this is something that people have run into before. The heatsoak is causing a thing puck of filament to form in the TINY gap between the PTFE tube and the mosquito's heatbreak. The issue really only presents itself in areas when the flow is very low, so several layers worth of solid infill in small perimeters causing the flowrate to stay low for long periods of time. (I am open to at least one comment with "just dial up your accel yolo")
I think this may be partially caused by EVA's design possibly being too constrictive on the hotend cooling fan, or possibly said fan just not being powerful enough.
Is this an issue anyone else has dealt with and do you have a solution for it?
3 replies