Euclius
RRCRat Rig Community [Unofficial]
•Created by Euclius on 2/28/2025 in #fix-my-printer
Klipper reports: SHUTDOWN
Hi, TheTik, it worked:)))!! I reflashed the raspberry, forget the RatOS hotspot in the wifi setings and went trough the instal steps again and it all worked out. Thank you a lot for helping me:))!!
20 replies
RRCRat Rig Community [Unofficial]
•Created by Euclius on 2/28/2025 in #fix-my-printer
Klipper reports: SHUTDOWN
yes, I'm on it, eager to finally print something.do you think i should disconnect all wires from the boards?
20 replies
RRCRat Rig Community [Unofficial]
•Created by Euclius on 2/28/2025 in #fix-my-printer
Klipper reports: SHUTDOWN
ok, i will reflash the SD card and start over. TheTik ,thank you for your time, I will come back and report the results.
20 replies
RRCRat Rig Community [Unofficial]
•Created by Euclius on 2/28/2025 in #fix-my-printer
Klipper reports: SHUTDOWN
no additional packages, just as instructed in the guide
20 replies
RRCRat Rig Community [Unofficial]
•Created by Euclius on 2/28/2025 in #fix-my-printer
Klipper reports: SHUTDOWN
20 replies
RRCRat Rig Community [Unofficial]
•Created by Euclius on 2/28/2025 in #fix-my-printer
Klipper reports: SHUTDOWN
no, there were no errors except warning about that i should put a jumper (which i did) on toolboard for more precise temp.readings
20 replies
RRCRat Rig Community [Unofficial]
•Created by Euclius on 2/28/2025 in #fix-my-printer
Klipper reports: SHUTDOWN
Yes, I updated in the right order, as instructed in ratrig commissioning guide.all is up to date
20 replies
RRCRat Rig Community [Unofficial]
•Created by Euclius on 2/28/2025 in #fix-my-printer
Klipper reports: SHUTDOWN
found it
20 replies
RRCRat Rig Community [Unofficial]
•Created by Euclius on 2/28/2025 in #fix-my-printer
Klipper reports: SHUTDOWN
Hi, TheTik, I would attach the debug.zip file but i don't know where it is or how to get it.can you please help me with it?
20 replies