Klipper reports: SHUTDOWN
Hi everyone. Just assembled VCore4 core XY, and going trough commissioning guide.After updating everything in “machine” tab, then successfully flashing control board and tool board and finishing the setup wizard get this orange message and after restart i get the red message.After firmware restart i get the orange one again.(apologies for speaking in so so simple words:). I auto reflashed control and tool board again but had the same messages.Im stuck , can’t figure out the problem and asking for your help🙏
16 Replies
Can you attach your debug.zip please?
Hi, TheTik, I would attach the debug.zip file but i don't know where it is or how to get it.can you please help me with it?
found it
Hm. How did you update everything? Did you click the "update all components" button?
If you can ssh into the raspi try running
ratos doctorYes, I updated in the right order, as instructed in ratrig commissioning guide.all is up to date
good, that is a common mistake. I see you said you tried to reflash the control board, were there any errors?
no, there were no errors except warning about that i should put a jumper (which i did) on toolboard for more precise temp.readings
Did you install any additional packages?
Can I see a picture of the Update Manager?
no additional packages, just as instructed in the guide
Interesting, as this is part of the error message that is cut off in the webpage:
If it was my own printer I'd try some stuff to get klipper to be not "dirty" but I'm not confident and would just be playing around. For an actual suggestion I'd try reflashing the SD card and starting over
ok, i will reflash the SD card and start over. TheTik ,thank you for your time, I will come back and report the results.
Best of luck! Fortunately it is a pretty fast process 🙂
yes, I'm on it, eager to finally print something.do you think i should disconnect all wires from the boards?
I think leaving them connected is fine
Hi, TheTik, it worked:)))!! I reflashed the raspberry, forget the RatOS hotspot in the wifi setings and went trough the instal steps again and it all worked out. Thank you a lot for helping me:))!!